SCREW

If the machine is showing misalignment, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. When downtime matters, having the correct part number helps. Screw is identified as part 03-1419-29. Hardware wear is often visible: elongated holes, stripped threads, or parts that won’t stay tight. Use part number 03-1419-29 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Once the root cause is corrected, performance should stabilize and output should return to normal. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period.