TOOTHED LOCKWASHER

Toothed Lockwasher is sold under part number 03-1417-24 for ice maker service and maintenance work. Stopping a persistent leak usually means replacing the sealing surface, not just tightening hardware. Symptoms can present as water intrusion, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Replacing a worn part early can prevent secondary damage to nearby components. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period.