TOOTHED LOCKWASHERS

Toothed Lockwashers (PN 03-1417-07) supports ice machine service when wear, damage, or fitment issues are disrupting normal operation. Seals, gaskets, and washers prevent leaks at joints and interfaces. Once compressed or torn, drips often return even after re-tightening. Symptoms can present as wet-floor complaints, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. A correct-fit replacement helps restore predictable operation and reduces repeat service calls. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.