NON-METALIC WASHERS

Non Metalic Washers is listed as part 03-1409-14 for ice machine replacement and service work. Symptoms can present as water intrusion, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. A solid approach is to confirm the symptom, then check mounting points and adjacent connections for contributing issues. Use part number 03-1409-14 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Replacing a worn part early can prevent secondary damage to nearby components. Stopping a persistent leak usually means replacing the sealing surface, not just tightening hardware. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period.