SPECIAL WASHERS

For technicians troubleshooting wet-floor complaints, Special Washers is a part that’s often inspected and replaced when failure is confirmed (part 03-1408-41). Seals, gaskets, and washers prevent leaks at joints and interfaces. Once compressed or torn, drips often return even after re-tightening. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. Replacing a worn part early can prevent secondary damage to nearby components. Replace this part when you see wet-floor complaints, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period.