SPECIAL WASHERS

Stopping a persistent leak usually means replacing the sealing surface, not just tightening hardware. For technicians troubleshooting leaks, Special Washers is a part that’s often inspected and replaced when failure is confirmed (part 03-1408-38). If the machine is showing leaks, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Use part number 03-1408-38 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Once the root cause is corrected, performance should stabilize and output should return to normal. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly.