SPECIAL WASHERS

Replace this part when you see leaks, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. A solid approach is to confirm the symptom, then check mounting points and adjacent connections for contributing issues. Special Washers is a replacement component listed as part 03-1408-08 for ice machines. Seals, gaskets, and washers prevent leaks at joints and interfaces. Once compressed or torn, drips often return even after re-tightening. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Replacing a worn part early can prevent secondary damage to nearby components. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period.