WASHER

Use part number 03-1407-08 when ordering Washer for a repair—especially when the symptom points to this section of the machine. Stopping a persistent leak usually means replacing the sealing surface, not just tightening hardware. Use part number 03-1407-08 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. A correct-fit replacement helps restore predictable operation and reduces repeat service calls. Replace this part when you see wet-floor complaints, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.