SCREW

Brackets, gussets, clamps, and fasteners keep assemblies aligned under vibration. Loose mounting leads to noise and repeat failures. Replace this part when you see loose parts, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. A solid approach is to confirm the symptom, then check mounting points and adjacent connections for contributing issues. Diagnosing loose parts can come down to one worn component—Screw (part 03-1403-36) is a common replacement item. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. Replacing a worn part early can prevent secondary damage to nearby components. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly.