SCREW

For technicians troubleshooting vibration rattles, Screw is a part that’s often inspected and replaced when failure is confirmed (part 03-1403-19). If the machine is showing vibration rattles, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. Replacing a worn part early can prevent secondary damage to nearby components. Hardware wear is often visible: elongated holes, stripped threads, or parts that won’t stay tight. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.