HARNESS PUMP

Part 02310092 (Harness Pump) is used when a confirmed fault requires replacing this specific component. It’s a pump replacement and is typically sourced after the failed harness pump is confirmed. Confirm the unit data tag and the old harness pump marking so part 02310092 matches the correct revision. In normal operation, this part moves water through fill, circulation, or drain stages. Failures tied to the harness pump can show up as no flow, drain problems, and intermittent pumping. Similar complaints can overlap across components, so diagnosis helps avoid unnecessary swaps. Good troubleshooting helps prevent repeat returns and unnecessary part swaps. Service verification for the harness pump often includes: inspect impeller for wear; confirm hoses/lines aren’t restricted. A confirmed swap to part 02310092 helps reduce repeat downtime and recurring intermittent faults. When you’re ready to replace the part, finish with a careful install and test. Order part 02310092, install the harness pump carefully, and run a full operating cycle test after replacement. Once part 02310092 is installed and tested, the unit should return to normal performance with fewer intermittent issues. Inspect related components so the new part isn’t exposed to the same stress that damaged the original. After the first test cycle, recheck hardware and connectors to confirm everything remains secure. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts. After the first test cycle, recheck hardware and connectors to confirm everything remains secure. After the first test cycle, recheck hardware and connectors to confirm everything remains secure. Document the symptom and the post-repair test result for future service history. Document the symptom and the post-repair test result for future service history. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts.