TUBE - DRAIN

Drain components guide melt water out of the unit. When they crack, loosen, or clog, water can back up and create leaks or overflow. If the machine is showing leaks, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Tube Drain is a replacement component listed as part 02-4708-01 for ice machines. Use part number 02-4708-01 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Replacing a worn part early can prevent secondary damage to nearby components. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.