DOOR ASSEMBLY

For technicians troubleshooting poor closure, Door Assembly is a part that’s often inspected and replaced when failure is confirmed (part 02-4655-13). Replace this part when you see poor closure, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. A solid approach is to confirm the symptom, then check mounting points and adjacent connections for contributing issues. Door and hinge parts affect closure and alignment. Poor fit can cause rattles, air leaks, and moisture intrusion. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. Replacing a worn part early can prevent secondary damage to nearby components. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period.