HINGE ASSEMBLY

Part 02-4655-12 corresponds to Hinge Assembly and is commonly purchased for ice maker repairs when the original component can’t be reused. Restoring smooth closure can prevent secondary issues caused by vibration and misalignment. Use part number 02-4655-12 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. A correct-fit replacement helps restore predictable operation and reduces repeat service calls. Replace this part when you see misalignment, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.