COMPRESSOR ASSY

For technicians troubleshooting no ice production, Compressor Assy is a part that’s often inspected and replaced when failure is confirmed (part 02-4655-06). The compressor drives the refrigeration cycle. Cooling loss can show up as long run times, slow production, or no ice when temperatures don’t pull down. If the machine is showing no ice production, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. A solid approach is to confirm the symptom, then check mounting points and adjacent connections for contributing issues. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. Replacing a worn part early can prevent secondary damage to nearby components. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.