BEARING REPLACEMENT

Bearing Replacement (PN 02-4578-01) supports ice machine service when wear, damage, or fitment issues are disrupting normal operation. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Replacing a worn part early can prevent secondary damage to nearby components. Keeping rotation smooth reduces strain on motors and drive components. Symptoms can present as rough movement, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.