DRIER Part obsolete, USE 16-1219-01

When downtime matters, having the correct part number helps. Drier is identified as part 02-4416-01. The listing indicates a supersession to 16-1219-01. Symptoms can present as unstable cooling, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Moisture and debris in the circuit can lead to unstable performance; the drier is a key protective element. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Once the root cause is corrected, performance should stabilize and output should return to normal. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly.