Sprayer Assembly - Part obsolete, USE 02-4371-03

Sprayer Assembly (PN 02-4371-02) supports ice machine service when wear, damage, or fitment issues are disrupting normal operation. The listing indicates a supersession to 02-4371-03. If the machine is showing wear, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. Use part number 02-4371-02 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Replacing a worn part early can prevent secondary damage to nearby components. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period.