Door-cu30 - Part obsolete, USE 02-4314-20

Door CU30 is a replacement component listed as part 02-4314-01 for ice machines. The listing name references model(s) CU30. The listing indicates a supersession to 02-4314-20. Symptoms can present as poor closure, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Replacing a worn part early can prevent secondary damage to nearby components. Restoring smooth closure can prevent secondary issues caused by vibration and misalignment. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly.