FILTER-AIR-CU30

This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. Filter Air CU30 (PN 02-4308-02) supports ice machine service when wear, damage, or fitment issues are disrupting normal operation. The listing name references model(s) CU30. Symptoms can present as noise, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. Replacing a worn part early can prevent secondary damage to nearby components. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly.