GRILL-INSERT-CU26

Part 02-4304-02 corresponds to Grill Insert CU26 and is commonly purchased for ice maker repairs when the original component can’t be reused. The listing name references model(s) CU26. Use part number 02-4304-02 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Replacing a worn part early can prevent secondary damage to nearby components. Good fitment reduces vibration noise and helps keep debris and moisture away from sensitive areas. Replace this part when you see exposed components, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly.