CHASE COVER

This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. If you’re sourcing Chase Cover, ordering by part number 02-4296-01 helps you match the correct listing. Replace this part when you see leaks, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. Use part number 02-4296-01 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. A correct-fit replacement helps restore predictable operation and reduces repeat service calls. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.