LABEL - CONTROLLER

For technicians working on Multiple brands equipment, Label Controller is identified by part number 02-4189-01 for replacement. If the symptom is unexpected shutdowns, inspect the part location for looseness, rubbing marks, mineral buildup, and any secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. Control components coordinate timing and outputs across the machine. When control logic fails, you can see no-start conditions, erratic cycling, or random shutdowns. Disconnect power before service. Reassemble so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, performance should stabilize and output should return to normal. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.