CONTROL MOUNTING PLA

If you’re troubleshooting won’t start on a Multiple brands unit, the Control Mounting Pla (part 02-4076-01) is a common replacement item. Technicians typically replace this part when they’re seeing won’t start, visible wear, cracking, corrosion, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. Control components coordinate timing and outputs across the machine. When control logic fails, you can see no-start conditions, erratic cycling, or random shutdowns. Match the part number 02-4076-01 to the old component before ordering, then reinstall with careful alignment and routing. Once the root cause is corrected, performance should stabilize and output should return to normal. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period.