STACKING CURTAIN RIG

For technicians working on Multiple brands equipment, Stacking Curtain Rig is identified by part number 02-3885-01 for replacement. Brackets, clamps, insulation, and fasteners keep assemblies aligned under vibration. Loose mounting leads to noise and repeat failures. Technicians typically replace this part when they’re seeing loose parts, visible wear, cracking, corrosion, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. Disconnect power before service. Reassemble so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, performance should stabilize and output should return to normal. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.