DRAIN HOSE

If the symptom is standing water, inspect the part location for looseness, rubbing marks, mineral buildup, and any secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. If you’re troubleshooting standing water on a Multiple brands unit, the Drain Hose (part 02-3826-02) is a common replacement item. Drain components guide melt water out of the unit. When the drain path leaks or backs up, you’ll see pooling, overflow, or wet-floor complaints. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Replacing a worn part early can prevent secondary damage to nearby components. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.