UPPER INNER SPLASH P

Multiple brands Upper Inner Splash P is listed under part number 02-3706-01 for ice maker service and replacement work. If the symptom is inconsistent operation, inspect the part location for looseness, rubbing marks, mineral buildup, and any secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. Disconnect power before service. Reassemble so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, performance should stabilize and output should return to normal. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period.