Flow Restrictor 1356 - Part obsolete, USE 02-3660-02

Part 02-3614-01 corresponds to the Multiple brands Flow Restrictor 1356, used in service situations where wear or damage is disrupting operation. The listing indicates this part is superseded by 02-3660-02. Disconnect power before service. Reassemble so nothing pinches, rubs, or binds once the unit is back together. Replacing a worn part early can prevent secondary damage to nearby components. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. Technicians typically replace this part when they’re seeing wear, visible wear, cracking, corrosion, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.