HOUSING - EYE

For technicians working on Multiple brands equipment, Housing Eye is identified by part number 02-3528-01 for replacement. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Once the root cause is corrected, performance should stabilize and output should return to normal. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. If the symptom is inconsistent operation, inspect the part location for looseness, rubbing marks, mineral buildup, and any secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.