DRIER Part obsolete, USE 16-1219-02

This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. Multiple brands Drier is listed under part number 02-3490-01 for ice maker service and replacement work. The listing indicates this part is superseded by 16-1219-02. Technicians typically replace this part when they’re seeing inconsistent operation, visible wear, cracking, corrosion, or a component that won’t stay seated. A good diagnostic approach is to confirm the symptom, then check mounting points and adjacent connections for contributing issues. Match the part number 02-3490-01 to the old component before ordering, then reinstall with careful alignment and routing. Replacing a worn part early can prevent secondary damage to nearby components. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period.